Instruction manual
14
PROFILING
1. Choose a proling template and clamp it to the template holder.
2. Measure the area of your skate that you would like to prole and mark up the blade. Use
the toe-pitch-heel sticker to help you. Always prole at least 60% of your skate.
3. Clamp the skate to the skate holder.
4. Push the ”Prole” button once and a light will start to blink. Now press the ”Sharp” but-
ton and the sledge will start to moving without the grinding wheel spinning.
5. Adjust the guide-roll´s height. When the guide-roll is moving over the template the
grinding wheel won’t prole the blade. And when it’s not touching the template, the
grinding wheel will cut of steel from your skate.
6. Put marks on the template when your satised with your settings. These markings will
show you where to prole the other skate in your pair.
7. To make the proling faster. You have the opportunity to choose which area of the skate
you would like to prole. Press the ”Prole” button on your control panel twice and
one full light will show. It indicates that the machine will sharpen between Proling dot
1 and 1. Two lights and the machine will sharpen between proling dot 2 and 2. and
nally 3 lights and it will sharpen between proling dot 3 and 3.
8. Choose the proling dots suited for your skate and press ”Sharp”. When using the pro-
ling dots, one push on the ”Sharp” button equals 5 cycles.
9. You may also increase the wheel pressure to fasten the proling process.
10. Remember. As long as the guide-roll doesn’t move, it proles the skate.
11. When the guide-roll is touching the whole template. the proling procedure is nished.
12. Before skating with your newly proled skates. Please re-dress the grinding wheel and
sharpen it to smoothen out the blade. See page 9 for how to dress the wheel.