Instruction manual

13
GRINDING OF FIGURE SKATES AND
BANDY SKATES
1. After dressing your grinding wheel, measure your skate and set the scale knob on the
same width as your skate.
2. Clamp the skate in to the skate-holder. The toe of your skate should always point to
your left.
3. Loosen the two nuts on the Figure skate device and slide it as far to your right as pos-
sible and tighten the nuts. (Take notice that the adjustment screw has to be located
under the gure skate device).
4. Move the sledge forward with the arrows on your control-panel until the grinding wheel
is located directly under the toe of your gure skate. Now adjust the height of your
wheel towards the skates toe with the adjustment screw.
5. Once in position, return the skate holder to its home position and start sharpening your
skate.
6. Choose number of grinding cycles by using the “SHARP” button. 1 push is worth of
1 cycle, 2 pushes is worth of 2 cycles and so on. Machine will start after choosing the
amount of cycles and will stop automatically once nished.
The grinding procedure is now successfully completed.
For more detailed instructions how to sharpen Figure and Bandy Skates, please take a look
at our Instructional Videos at www.prosharp.com
AS2001 Allpro