Operating instructions

Page 9
Dressing of the grinding wheel with regular hollow
1. Make sure that the scale-knob is set at 3.0
2. Choose your hollow and move the skateholder by using the arrows on the
control-panel
3. The hollow radius sticker on the skateholder indicates wich hollow you want
to dress. Once set, lock the wheel arm.
4. Adjust the diamond tool downwards until it barely touches the surface of the
grinding wheel.
5. When you choose to make a regular hollow make sure the knob on the dress
units handle is lifted and locked in the upper position.
6. Push the “DRESS” button on the control-panel once. The wheel starts to run.
Carefully move the handle of the dress unit back and forth until the grinding wheel is fully
dressed with a smooth surface.
Once you are satisfied, press “DRESS” button again to stop the wheel.
Unlock the wheel arm and screw the diamond tool upwards.
Dressing of the grinding wheel with Channel Z
When you choose to make a radius hollow combined with a channel, choose first
the hollow radius, and follow instructions how to dress. Once dressed, let the
wheel arm be locked and turn the knob on the dress units handle to its lower
position.
Choose S, M or L width of the channel by screwing the Channel Z -thumbscrew
in or out to make the tap on the diamonds handle hit it. Follow the scale to see
what width you get.
1. Push “DRESS” button and screw down the diamond tool approximately ½-turn (for a 0,5mm
deep channel) Dress on side of the wheel by moving the handle until the tap hits the Channel Z -
thumbscrew
2. Lift and lock the knob on the dress units handle in its upper position, unlock wheel arm and push
the grinding wheel down. Now move the diamond tool over to the other side of the metallic
Channel Z thumbscrew while the arm remains in a lower position. Now move the grinding wheel
arm up and lock it. Turn the knob on the dress units handle down to its lower position, dress the
other side of the wheel until tap hits the Channel Z -thumbscrew (remember not turning the