Operating instructions

Page 12
2. Put your toe pick on any of the profiling dots on the skate holder. Then clamp
your skate.
Choose from “PROFILE” from which point the skate-holder will turn back. See
pictures 6 & 7. Two pushes one light will go on and the skate-holder will
turn back from the “1 point mark”. 3 pushes 2 lights and the skate-holder will
turn back from the “2 points mark”. 4 pushes 3 lights and the skate-holder will
turn back from the “3 points mark”.
3. Choose number of grinding cycles by using the “SHARP” button. 1 push is worth
of 1 cycle, 2 pushes is worth of 2 cycles and so on. Machine will start after
choosing the amount of cycles and will stop automatically once finished.
Check the result and the skate is finished.
For more detailed instructions how to sharpen Figure –and Bandy Skates, please
take a look at our Instructional Videos at www.prosharp.com