Operating instructions

Page 11
Grinding of figure skates and Bandy skates
Alternative 1:
Sharpening with the Figure Skate Device
1. After dressing your grinding wheel, measure your skate and set the scale knob
on the same width as your skates.
2. Clamp the skate in to the skate-holder. The toe of your skate should always point
to your left.
3. Loosen the two nuts on the Figure skate device and slide it as far to your right as
possible and tighten the nuts. (Take notice that the adjustment screw has to be
located under the figure skate device).
4. DO NOT SHARPEN YET! Move the sledge forward with the arrows on your
control-panel until the grinding wheel is located directly under the toe of your
figure skate. Now adjust the hight of your wheel towards the skates toe with the
adjustment screw.
5. Once in position, return the skate holder to its home position and start sharpening
your skate.
6. Choose number of grinding cycles by using the “SHARP” button. 1 push is worth
of 1 cycle, 2 pushes is worth of 2 cycles and so on. Machine will start after
choosing the amount of cycles and will stop automatically once finished.
Check the result and the skate is finished.
Alternative 2:
1. After dressing your grinding wheel, measure your skate and set the scale knob
on the same width as your skates.