Instructions / Assembly

4011 Avenida de la Plata Ste. 302, Oceanside, CA 92056 ● www.YourGaragePro.com
[phone] ● [phone] ● Fax [phone] ● Email: [e-mail]
58026, 58036 ProSeal
™
Weather Seal
Installation Instructions
Note: The corner of the ProSeal™ must be positioned in the corner, formed by the
door jam and the door, when the door is closed. The shorter, thicker side of the
ProSeal™ will be nailed to the door jam, while the longer, thinner side will press up
against the garage door.
1. Cut the ProSeal™ to the match the lengths of the top and sides of the door jam,
leaving about an inch extra.
2. Close the garage door.
3. To install the top piece, start at one corner and position the ProSeal™ so the
longer, thinner side is pressing against the garage door. Attach the top piece
across the door jam, using the galvanized roofing nails included in the kit. The
first nail should be positioned as close to the corner as possible, with the
remaining nails positioned 4” apart. As you approach the end, trim off the extra
ProSeal™ so it fits snuggly into the corner.
4. To install the side pieces, start at the top and attach the side piece as described
above.
The ProSeal™ can be painted to match your home, by using the same paint that was
used on the door jam.