User's Manual

INDUSTRIAL 4G LTE CELLULAR ROUTER - UM V1.1.8
77
The status tab shows the information from the settings of static route.
IP Routing > RIP
This section allows you to configure RIP and select the mode from Disable or Enable. The default
is Disable.
Note:
RIP (Routing Information Protocol, RFC 2453) is an Interior Gateway Protocol (IGP) and is
commonly used in internal networks. It allows a router to exchange its routing information
automatically with other routers, and allows it to dynamically adjust its routing tables and adapt to
changes in the network.
IP Routing > Static Route > Status
Item
Description
Mode
The setting is open for full network. Select from Off or On.
Status
Destination
Show the status of destination from the setting section.
Gateway
Show the status of gateway from the setting section.
Interface
Show the status of interface from the setting section.
Protocol
Show the status of protocol from the setting section.