User's Manual

INDUSTRIAL 4G LTE CELLULAR ROUTER - UM V1.1.8
178
You can click the Edit button to configure COM2 setting. The configuration UI shows the following
picture.
The configuration UI provides the serial setting and the Virtual COM setting.
(1) For the serial setting, you need to change the setting like baud rate to fit the connected device.
(2) For the Virtual COM, you need to change the mode to Server and specify the Protocol, Port
to reach the remote management feature. (
Note: In this case, we use the TCP and port 6000
to be the Virtual COM server settings.)
(3) Click the Close and the Apply button. If all settings are correct, the web UI will display Apply
OK.
(4) Then you can open the Virtual COM software on PC. (
Note: In this case, we use the USR-
VCOM to be the Virtual COM software.)
(5) And set up the virtual serial port by 192.168.1.1 (The default is LAN IP), TCP client and