User's Manual

INDUSTRIAL 4G LTE CELLULAR ROUTER - UM V1.1.8
116
 Hub configuration
Hub IPsec configuration
In this example, we have two spokes on the topology. Thus, the Hub needs to set two IPsec
connections for each spoke.
1. Change Mode from Disable to Enable.
2. Change Type from Policy-based to Route-based.
3. Navigate to the
Authentication IDs tab.
4. Add the default pre-shared key
 ID: (The ID is blank.)
 Type: PSK
 Pre-shared Key: defaultpsk
5. Add the authentication ID for Spoke 1
 ID: spoke1
 Type: PSK
 Pre-shared Key: testspoke1
6. Add the authentication ID for Spoke 2
 ID: spoke2
 Type: PSK
 Pre-shared Key: testspoke2
7. Apply the changes
8. Navigate to the
Connections tab
9. Add IPsec connection for Spoke 1
(1) Edit the phase 1 setting
(2) Change Mode from Disable to Enable
(3) Change the Remote ID and select the spoke1 (PSK) authentication ID
(4) Save the changes
10. Add IPsec connection for Spoke 2
(1) Edit the phase 1 setting
(2) Change Mode from Disable to Enable.
(3) Change the Remote ID and select the spoke2 (PSK) authentication ID
(4) Save the changes
11. Apply the changes