Specifications

WILL NOT RECORD OR PLAY

• Check to make sure there is a tape in the VCR.

• Try ejecting and reinserting the cassette.

• Check to make sure the tape is not broken.

• Check to make sure the VCR is not in pause mode. Press PAUSE or PLAY to return to

normal playback.

• Check the Pro-Tect Plus TM feature.

WILL NOT RECORD

• Check to make sure the safety tab is intact.

REWIND DOES NOT OPERATE

• Check to make sure the tape is not already rewound.

VCR PLUS+ OR TIMER RECORDING NOT MADE OR WRONG PROGRAM RECORDED

• Check to make sure the correct VCR Plus+ code is entered.

• Check to make sure the cable box or satellite receiver was turned on when recording was

to begin.

• Check to make sure the program was entered correctly (wrong channel or times).

• Power interruption. Reset the clock.

• Check to see if time and date are correct--including AM/PM.

• Check to make sure the program did not exceed the tape's length or the tape was not

rewound beforehand.

• Check to make sure the VCR was turned off at the time recording was to start.

• Check to make sure there was a tape in the VCR and the cassette's safety tab was intact.

• VCR ejects cassette when the end of the tape is reached during a timer recording.

• Check to make sure VCR Plus+ setup was completed correctly.

CLOCK SHOWS INCORRECT TIME OR DATE

• Power interruption. Automatic clock set was not turned on or did not work properly.

Check time zone and daylight-savings settings.

• Make sure VCR or cable box is tuned to channel carrying AIISet information.

• Auto clock set is not supported by digital satellite receivers. Set the clock manually.

TIME DID NOT ADJUST FOR DAYLIGHT-SAVING TIME

• Check to make sure daylight-saving feature is set correctly.

VCR MAKES NOISE WHEN STOPPED

• VCR is removing tape from heads. This is normal. The head cylinder inside the VCR will

continue to rotate for a few minutes after you put the VCR in the stop mode.

WILL NOT AUTO CHANNEL SEARCH ACTIVE CHANNELS CORRECTLY

• Check to make sure the antenna connections are secure and correct.

• Check to make sure the Signal Type: CABLE/ANTENNA feature is set correctly.

• If Detect Automatically was selected for the Signal Type in the AUTO CHANNEL SEARCH

menu, try using either CABLE TV or ANTENNA instead.

• May not be necessary if using a cable box for all channels. Contact your local cable

company for more information.