Specifications

THINGS TO KNOW BEFORE
CONNECTING COMPONENTS
PROTECT YOUR COMPONENTS
FROM POWER SURGES
Connect all components before plugging any power cords
into the walt outlet.
Always turn off the TV and other components before you
connect or disconnect any cables.
POSITION CABLES CORRECTLY TO
AVOID AUDIO HUM OR INTERFERENCE
Insert all cable plugs firmly into their jacks.
Place the audio/video cables to the sides of theTV's back
panel instead of straight down the middle after you
connect your components.
Try not to coil any twin-lead cables and keep them away
from the audio/video cables as much as possible.
Make sure all antennas and cables are properly grounded.
Refer to the SafetyTips sheet packed with your unit.
PROTECT YOUR COMPONENTS FROM
OVERHEATING
Do not block ventilation holes in any of the components.
Arrange the components so that air can circulate freely.
Do not stack components.
Allow adequate ventilation when placing your
components in a stand.
Place an amplifier or satellite receiver on the top shelf of
the stand so heated air rising from it will not flow around
other components.
7
V
V
V
V
V
¥
CONNECTIONS
V
59