Specifications

Repeat step 3 until the component turns off or you have

searched through all of the codes.

To cancel Code Search, press and hold CLEAR until the

LED turns off.

There are 20 total sets of codes. If the device does not turn

off after pressing PLAY 20 times, the remote cannot control

that particular component.

If the component you want to control does turn off:

1. Press and release REVERSE, then wait two seconds. Repeat

this step until the component turns back on. This means

the remote has identified the correct code.

2. To finish, press and hold STOP until the LED turns off.

USING DIRECT ENTRY

Direct Entry is another way to program your remote if the

Automatic Code Search is unsuccessful.

1. Turn on the component to be programmed.

2. Look up the brand and code number(s) for the component

in the code list at the end of this chapter.

3. Press and hold the button on the remote you want to

program.

4. Enter the code from the list at the end of this chapter.

5. Release the button, and then press ON.OFF to see if the

component responds to the remote commands. If it

doesn't, try pressing the component button and then

ON.OFF again.

6. Repeat these steps using the next code listed for your

brand if you get no response.

OPERATING COMPONENTS

After programming the remote, see which buttons operate your

component.

1. Point the remote at the component, and press its

corresponding button on the remote.

2. Experiment to see which buttons operate your component.

Try pressing buttons that relate directly to the component.

TheVCR's remote control may

not operate all models and/or

brands of components.

Note the difference between the

VCR and other component's on-

screen displays to determine

which one the remote control is

operating.