Specifications

ABOUT PROGRAMMING THE
REMOTE
The universal remote's TV and SAT,CABLE buttons can be
programmed to control other brands of remote controlled TVs,
digital satellite receivers, and cable boxes. Your remote is
already programmed to operate most Proscan, RCA, and GE
televisions as well as digital satellite receivers.
The AUX button can be programmed to control a Proscan or
RCA auxiliary component.
TESTING THE REMOTE
To determine whether the universal remote needs to be
programmed, turn the component on (such as a TV), point the
remote at the TV and press the TV button. Then press ON,OFF,
CH +, or CH - to see if the TV responds to the remote
commands. If the TV does not respond, then the remote control
needs to be programmed.
PROGRAMMING THE REMOTE TO
CONTROL A TV, SATELLITE RECEIVER,
OR CABLE BOX
The remote features Code Search, a technology that largely
automates the programming process. Follow these steps to
program the remote to control a TV, digital satellite receiver, or
cable box.
,
2.
Turn on the component you want to control (TV, digital
satellite receiver, or cable box).
Press and hold the button you want to program (TV or
SAT,CABLE). While holding the component button, press
and hold ON,OFF until the LED on the remote flashes, then
release both buttons.
3. Press and release PLAY, then wait five seconds.
The remote searches through a set of codes. If, after five
seconds, the component does not turn off, press PLAY again
to tell the remote to search the next set of codes.
You can press FORWARD to individually search through the
last ten codes that were transmitted when you pressed PLAY.
ON,OFF
AUX
LED
I REVERSE PLAY FORWARD
You'll use these buttons when you
program the remote to control a
TV, digital satellite receiver, or
cable box.
40