Specifications

AUTO CHANNEL SEARCH

Now scanning channel 14

Press any key to cancel

The VCR begins scanning for the available channels--this

takes about one to two minutes. When the scan is complete,

the VCR tunes to the lowest channel number available. At

this point, pressing CHAN + or - on the remote should only

select active channels.

CHANGING THE SIGNAL TYPE

This feature is useful if your cable signal goes out; it allows you

to switch to a regular antenna for alternate television reception.

1. Press MENU to display the VCR MAIN MENU.

2. Press 4 to display the CHANNELS menu.

CHANNELS

I Auto _hannel Search

2 Add/Remove Channels

A VCR Plus+ Channel List

5 Cable Box Setup

6 SAT Setup

0 Exit

3. Press 3 to change the Signal Type between Cable and

Antenna. When you are finished, press 0 to exit back to the

Main Menu and 0 again to exit to normal viewing.

ADDING OR REMOVING CHANNELS

You may want to add or remove channels after you auto

channel search, especially if channels have weak signals or

content you don't want to watch. To achieve this:

1. Press MENU to display theVCR MAIN MENU

2. Press 4 to display the CHANNELS menu

3. Press 2 to display the ADD/REMOVE CHANNELS screen.

Use the CHANNEL + or- buttons on the remote or enter a

specific channel number with the number buttons to go to

the channel you want to add or remove.

Selecting Channels

The CHANNEL + and - buttons

access those channels which are

active in yourVCR channel list.

You can still access channels not in

the channel list by using the

number buttons on the remote.