Specifications

Noisy stereo reception

• May be a weak station. Use AUDIObutton to change STEREO/SAP

function to MONOmode instead of STEREO.

No picture, no sound but power light is on

• Maybe someone changed CABLE/AIRfunction to wrong position.

• Maybe a vacant channel is tuned.

• For Channels 90, 91, and 92, make sure the component

connected to those INPUTjacks is turned on in order to see

picture.

• If watching VCR (connected only through antenna input),

make sure TV is tuned to channel 3 or 4 - same as CHa/CH4

switch on VCR. Also check to make sure TV/_/CRswitch on

VCR is in correct position.

Sound okay, picture poor

• Check antenna connections.

• Try adjusting •SHARPNESSfunction to improve •weak.signals.

Can't get two channels for picture-in-picture .

• One channel must comethrough ANTA or B connector and the

Other channel inust coine through the INPUT1or 2jacks.

_'If using ihe VCR1Or VCR2button, make sure it is programmed to

Select the proper video input channel as described on page 24..

• Check position of TV/VCRswitch on VCR.

, If using an S-.VHS component, make sure its regular VIDEOcable

is connected to INPUT1VIDEOjack on TV. •

No picture while using picture-in-picture, with S-VHS VCR

or camcorder

• If you have an S-VHS VCR or camcorder connected, you must

• also connecta cable from the VCR's VIDEOOUT jack to the

TV's corresponding VIDEOINPUTI jack in addition to the S-VHS

cable. •

Small :picture does not have color

• The small picture will not'have color if the large picture signal

does not have the color burst rcfcrcncc. All colorsignals and

some black-and-white signals are sent with color burst. Try

chan.ging the channel of the big picture.

Black Box appears on the scree,l:

Turn off the CAPTIONING fcalurc.