How to Guide

Other tips:
 Verify pressure tank and bladder is in good working order before replacing pressure switch. Damaged or bad
pressure tanks will not allow the switch to operate properly
 Verify there are no leaks in the well system before replacing pressure switch. Leaks can cause the switch to
rapid cycle and damage the switch.
 Verify your pump is capable of creating the pressure to signal the pressure switch to turn off.
 This pressure switch is pre-set from the factory, please verify proper operation of the switch several cycles
before you decided to adjust the pressure switch to accommodate your needs. Please see pressure switch
instructions.
 Verify your water pressure gauge is working properly before installing your pressure switch. If you do not have
a water pressure gauge, we recommend installing one before installing your pressure switch.
 Model number PPSL3050, lever MUST be held in the start position until the pump builds within 10psi or less of
the start pressure for proper operation.
Please see instruction manual for complete installation instructions and troubleshooting. Or call 800-346-7611 for
Technical Support.