User Guide

ProPlex FloppyDrive Digital DIN Quick Start Guide, v1.2 14 June 2021 2
Setup
ProPlex DIN Rail devices use a standard Phoenix MSTB screw terminal connector in
various pin configurations. Please refer to the wiring diagrams below for correct hook
up of your ProPlex DIN Rail product.
The ProPlex FloppyDrive Digital DIN Rail must operate at 24 VDC. It can drive a
maximum of 15m of 12W per meter Firefly FloppyFlex Digital LED neon and can
control a maximum of 120 pixels of RGB.
Addressing and mode selection is done via RDM protocol.
1. Connect the DC power (24V) to the power input located in the left top corner. The
connector should be wired as follows: