User Manual

SETTING SLICES AND LOOPS

Using Sensitivity

Most of the time when working with ReCycle, you will want to cut your loop up

into slices. A slice is a section of the waveform, from one slice marker to the next.

When you load or receive a loop, ReCycle analyzes it to determine where slice

markers should appear (where the individual sounds in the loop are).

The Sensitivity slider is then used by you, to set the overall amount of slices. The

higher the sensitivity, the more slices you will get. And, the more slices you have,

the smaller entities ReCycle will cut the loop into, when you save it. For more in-

formation, see page 49.

The number to the right of the slider represents the current position of the slider,

where 0 represents minimum sensitivity and 99 maximum sensitivity.

As described below, the quickest way to get a good selection of slices is to set

the sensitivity quite high, roughly between 70 - 80, and then use the Mute Tool

to deactivate any slices you don’t need (see later in this chapter for details on

the Mute Tool).

Setting Sensitivity using the Keyboard

You can type a number on the typewriter part of the keyboard, di-

rectly.

This can be used to quickly give the slider a rough setting. If you hit “1” it

gets set to “11", if you press “2” it gets set to “22” etc.

You can use the [+] and [–] keys to “nudge” the slider up and down.

About Stereo and Mono

For stereo files, ReCycle analyzes both channels for slice points. In all respects,

the methods you can use and other considerations are the same regardless

whether the audio is in stereo or mono.

Slices always cut across both channels at the same position in the waveform,

they are not channel independent.

Using the Mute tool

You might run into situations where there are too many slices on the screen. You

could of course reduce the Sensitivity to get rid of the slice markers you don’t

want, but then other slice markers could disappear too, and this might not be de-

sirable. What you need to do in a situation like this is to “mute” an individual

slice, and this is just what the Mute Tool lets you do: When you select the Mute

Tool and click on a slice marker it gets diminished and its line disappears.

Before and after Muting a slice marker.

To try the effect of Muting, proceed as follows:

1. Click on two adjacent slices which play one sound each.

2. Mute the marker that divides the two slices.

3. Click again to audition.

You will hear that what was previously two slices is now one.

A slice marker

A slice