Specifications

USING
19
Connecting keyboards, mixers or other electronic instruments
1. Connect your instrument/mixer to any of the 1/4” jacks marked ‘LINE 1’ or ‘LINE 2’.
These jacks are designed especially for line level signals and accept balanced (TRS) plugs. However, it’s also
possible to connect and use unbalanced cables with TS (Tip+Sleeve) plugs.
D Connect both the LEFT and RIGHT inputs if your instrument has stereo outs (two mono cables).
Connecting a synthesizer (in stereo) to one of the LINE input pairs
2. Set your instrument's/mixer’s output level somewhere between 80-100% of max volume.
3. Press the appropriate LINE button(s) on the front panel and adjust the input signal level(s) by turning the
corresponding Input Level knob(s) (see “Adjusting input levels”).
Selecting Line Input(s) and adjusting the input level(s)
! If your instrument is connected to the Propellerhead Balance audio interface in stereo (via two mono cables),
make sure both Input Level knobs on Propellerhead Balance are set to identical positions. Otherwise the
stereo panning of the connected instrument will not be correct.
Right
Left
Right
Left
Line 1 Left
Line 1 Right
Line 2 Left
Line 2 Right
Channel 1/L
input level
Channel 2/R
input level