Specifications

USING

! Consult the manual for your microphone for information about specific power requirements.

Connecting a condenser microphone to one of the MIC inputs and activating 48V Phantom Power

When 48V Phantom Power is active on a MIC input, the corresponding 48V LED lights up on the front panel:

The 48V LEDs for MIC inputs 1/Left and 2/Right on the front panel

4. Make sure the appropriate MIC Input Selector button is selected on the front panel. Then, adjust the input

signal level by turning the corresponding input level knob (see “Adjusting input levels”).

Selecting MIC Input source and adjusting input level

5. Raise the volume (Main Out Level knob and/or Headphones Level knob) to a comfortable level.

! Before disconnecting a microphone, turn the Main Out Level knob, Headphones knob (if headphones are

used), and the corresponding input level knob(s) all the way down. If you are using a condenser microphone,

then switch off the Phantom Power by pressing the corresponding 48V button on the rear panel and wait for 15

seconds before disconnecting the microphone.

48V Phantom Power switches

Condenser microphone

MIC 1/Left

MIC 2/Right

Channel 1/L

input level

Channel 2/R

input level