Specifications

USING
15
Connecting Propellerhead Balance to an amplification
system
! Before connecting audio cables between Propellerhead Balance and an amplifier+speaker system, or
powered monitor speakers, make sure the Main Out Level knob on the Propellerhead Balance audio interface
is set to a low value and that the volume on your amplifier/powered monitors are set to a low value. Loud
volumes could cause hearing damage!
The Main Out Level knob
1. Connect a balanced (TRS) or unbalanced (TS) 1/4” plug cable between the Left Out of the Propellerhead
Balance audio interface and the left input of your amplifier/powered monitor speaker.
Connecting powered monitor speakers
The Main Out jacks of the Propellerhead Balance interface are balanced for a minimum of noise sensitivity.
However, you can connect unbalanced cables to these as well - it won’t damage the interface.
2. Connect another cable between the Right Out and the right input of your amplifier/powered monitor speaker.
3. Adjust the volume by turning up the Main Out Level knob.
The Main Out Level knob
D You might also need to adjust the volume on your amplifier/powered speakers.
! Before switching off your computer with the Propellerhead Balance interface connected, be sure to switch off
or turn down the volume completely on your amplifier/powered monitor speakers to avoid loud pops!
Right
Left