Specifications

NN-19 SAMPLER
149
Connections
On the back panel of the NN-19 you will find the connectors, which are mostly
CV/Gate related.
Audio Outputs
These are the main left and right audio outputs. When you create a new NN-19
device, these are auto-routed to the first available channel on the audio mixer.
Mono Sequencer Control
These are the main CV/Gate inputs. CV controls the note pitch. Gate inputs trig-
ger note on/off values plus a level, which can be likened to a velocity value. If you
want to control the NN-19 from a Matrix Pattern Sequencer for example, you
would normally use these inputs. The inputs are “mono”, i.e. they control one
voice in the sampler.
Modulation Inputs
! Remember that CV connections will not be stored in the sample
patch, even if the connections are to/from the same NN-19 device!
These control voltage (CV) inputs (with associated voltage trim pots), can mod-
ulate various NN-19 parameters from other devices, or from the modulation out-
puts of the same NN-19 device. These inputs can control the following
parameters:
• Osc (sample) Pitch
• Filter Cutoff
• Filter Resonance
• Amp Level
• Mod Wheel
Modulation Outputs
The Modulation outputs can be used to voltage control other devices, or other
parameters in the same NN-19 device. The Modulation Outputs are:
• Filter Envelope
• LFO
Gate Inputs
These inputs can receive a CV signal to trigger the envelopes. Note that con-
necting to these inputs will override the “normal” triggering of the envelopes. For
example, if you connected a LFO output to the Gate Amp input, you would not
trigger the amp envelope by playing notes, as this is now controlled by the LFO.
In addition you would only hear the LFO triggering the envelope for the notes
that you hold down.
• Amp Envelope
• Filter Envelope