Installation Manual
Table Of Contents
- Table of Contents
- Introduction
- Installation
- Requirements
- About the Audio Hardware
- About MIDI Interfaces
- Installing the Software
- Upgrading from an earlier Reason version
- Running the Installer
- The Authorization system
- Registering and authorizing Reason
- About deauthorizing the computer
- Running Reason on an authorized computer - or with an Ignition Key hardware
- Running Reason with Internet Verification
- Running Reason in Demo Mode
- Using Reason with ReWire on a 64-bit operating system
- Setting Up
SETTING UP
27
Setting up the Audio Hardware
In case this wasn't done in the Setup Wizard, you need to establish a connection between Reason and the
audio hardware. This is done by selecting a driver - a software component that acts like a link between the
program and the audio hardware. Proceed as follows:
1. In the Preferences dialog, click the Audio tab.
2. Pull down the Audio card driver pop-up menu and select one of the available drivers.
Which driver to select depends on the platform and the audio hardware. If an option is not applicable to
your setup it will be disabled in the dialog.