Installation Manual
Table Of Contents
- Table of Contents
- Introduction
- Installation
- Requirements
- About the Audio Hardware
- About MIDI Interfaces
- Installing the Software
- Upgrading from an earlier Reason version
- Running the Installer
- The Authorization system
- Registering and authorizing Reason
- About deauthorizing the computer
- Running Reason on an authorized computer - or with an Ignition Key hardware
- Running Reason with Internet Verification
- Running Reason in Demo Mode
- Using Reason with ReWire on a 64-bit operating system
- Setting Up
SETTING UP
24
About this Chapter
This chapter describes the settings you need to make before you can start using Reason. These are
necessary in order to get any sounds to and from the program and to be able to play and control Reason
via MIDI.
First run - Reason Setup Wizard
If you followed the instructions correctly in the last chapter, Reason should be running, and the first dialog
in the “Reason Setup Wizard” guide should be open.
This only appears the very first time the program is run.
! Note that the Language page only appears in the Windows version of Reason.
In Mac OS X, the selected system language is used.
! Note that any setting you make in the Setup Wizard can be changed later on in the Pref-
erences dialog.
D Clicking “Next” will take you through a series of dialogs, where the following happens: