Operation Manual

BV512 VOCODER
667
9. You can also adjust the vocoder sound by clicking and dragging the bars in the lower display.
Each bar corresponds to a frequency band, with low frequencies to the left and high frequencies to the right. You
adjust the level of a band by dragging its bar up or down. Clicking and dragging across the bars allow you to
change the levels of several bars, much like drawing an eq curve.
The upper display shows the spectrum of the modulator signal, for display only.
D To reset a band to ±0 dB, press [Ctrl](Win) or [Cmd](Mac) and click on it.
You can also reset all bands to zero by bringing up the context menu for the Vocoder device and selecting “Reset
Band Levels”.
10.If the vocoder sound is “muddy” or indistinct, try raising the “HF Emph” knob on the Vocoder.
This parameter (High Frequency Emphasis) boosts the high frequencies in the carrier signal.
11.Try out the other parameters if you like.
See “BV512 parameters” for details.
Using the BV512 as an equalizer
The BV512 has a unique equalizer mode, in which the device works purely as an insert effect (the modulator input
isn’t used). This allows you to use the processing filters of the vocoder as a kind of graphic equalizer.
Setting up
1. Select the device that you want to process through the BV512.
2. Create a BV512 device.
It is automatically connected as an insert effect, using the Carrier Input jacks.
3. Set the switch to the left of the displays to “Equalizer”.
In use