Operation Manual

DR. OCTO REX LOOP PLAYER
570
Connections
On the rear panel of Dr. Octo Rex you will find the connectors. The left part of the panel houses a number of CV/Gate
inputs and outputs. Using CV/Gate is described in “Routing Audio and CV”.
Modulation Inputs
These control voltage (CV) inputs (with trim pots), allow you to modulate various Dr. Octo Rex parameters from other
devices (or from the modulation outputs of the Dr. Octo Rex device itself). The following CV inputs are available:
•Master Volume
•Mod Wheel
• Pitch Wheel
• Filter Cutoff
• Filter Resonance
•Osc Pitch
Modulation Outputs
The Modulation outputs can be used to voltage control other devices, or other parameters in the Dr. Octo Rex device
itself. The Modulation Outputs are:
• Filter Envelope
The Filter Envelopes in Dr. Octo Rex are polyphonic (one per voice). Only the filter envelope of voice 1 is output
here.
•LFO
Gate Inputs
These inputs can receive a CV/gate signal to trigger the two envelopes. Note that connecting to these inputs will
override the “normal” triggering of the envelopes. For example, if you connected an LFO CV output on another device
to the Gate Amp input on the Dr. Octo Rex, the amplitude envelope would not be triggered by the incoming MIDI
notes to the Dr. Octo Rex device, but by the LFO CV signal. In addition you would only hear the LFO triggering the en-
velope for the slices that were playing at the moment of the trigger.
•Amp Envelope
• Filter Envelope
Gate Output
This outputs a gate signal for each triggered slice in the loop.