Operation Manual

MIXER 14:2
374
Auxiliary (AUX) Send Out
D There are four stereo Send Out connectors, which normally are used to connect to the inputs of effect devices.
To connect a send to a mono-input device, use the Left (Mono) output.
When a Send is connected to an effects device, the corresponding AUX Send knob determines the level of the signal
sent to the effect device for each channel. The Send Output is taken post-channel fader but you have the option of
selecting pre-fader mode for AUX Send 4.
D Note that some effects (for example the Comp-01 compressor or the PEQ2 parametric EQ) are effect types
which are not designed to be used as AUX Send effects, but rather as insert effects, where the whole signal is
passed through the effect.
Alternatively, you could use AUX Send 4 in pre-fader mode and lower the channel fader completely.
Auxiliary (AUX) Returns
D There are four stereo Return input connectors.
These are normally connected to the left and right outputs of effect devices.
Master Left/Right Outputs
• The Master outputs are auto-routed to the first available output pair on the Hardware interface.
This in turn sends the audio to the outputs of your audio hardware.
q Note that the Master outputs don’t have to be routed directly to the Hardware Interface. You could for example
route the Master outputs to an effect, and then route the effect outputs to the Hardware Interface instead.