Operation Manual

MIXER 14:2
371
Channel Strip Controls
|
Item
|
Description
|
Range
Channel Fader The channel fader is used to control the output level of each corre-
sponding channel.
By adjusting the faders, you can set the desired mix (balance) between
different devices connected to the Mixer.
0 - 127
Channel Label Each channel in the mixer that has a device connected to it, displays a
read-only label with the name of the device to the left of the fader.
N/A
Channel Meter The meter is a graphical representation of the channel output level. If
the signal level pushes the meter into the range of the red area, try low-
ering either the output level of the device connected to the channel, or
the channel fader itself, to avoid distortion.
N/A
Pan Control Use this control to set the left/right position of the channel in the ste-
reo field. [Command]/[Ctrl]-click the Pan knob to set Pan to the default
“0” (center position).
-64 – 0 – 63
Mute (M) and
Solo (S) Buttons
Clicking a channel’s Mute button silences the output of that channel.
Click the button again to unmute the channel.
Clicking a channel’s Solo button silences all other mixer channels, so
that you only hear the soloed channel. Several channels can be soloed
at the same time, but if this is the case, note that soloed channels can’t
be muted with the Mute button. To mute one of several channels in
solo mode you simply “unsolo” it.
On/Off
EQ Treble and Bass controls The EQ Treble and Bass controls is used to cut or boost the higher and
lower frequencies of the signal, respectively. Click on the EQ button to
activate the EQ.
If you need more advanced EQ, you can always use a PEQ2 parametric
EQ as an insert effect for a device.
Note also the two EQ modes - see “About the EQ modes”.
Treble: +/- 24 dB at 12 kHz.
Bass: +/- 24 dB at 80 Hz.
Auxiliary (AUX) Effect Send 1-4 The four independent AUX Sends control the amount of channel signal
that is to be sent to other devices - typically effect processors. The ef-
fect output is then normally returned to the Mixer via the AUX Return
inputs (see “The Auxiliary Return Section”) where it is mixed with the
dry (non-processed) signal. If you create an effect device when the
Mixer is selected, the effect is auto-routed to the first available Send/
Return connectors. You can then control the amount of effect that is to
be applied to any device connected to a Mixer channel via the corre-
sponding AUX Send knob. The AUX Send outputs are taken post
channel fader, but you have the option of selecting Pre-fader mode for
AUX Send 4 (by clicking the “P” button next to the send so that it lights
up). In that mode, the send level is independent of the channel fader.
The sends are in stereo but can be used in mono as well.
0 - 127