Operation Manual

WORKING WITH THE RACK
207
3. With the mouse button pressed, drag the device(s) to the new destination in the rack.
A thick red vertical line indicates where the device(s) will be positioned. Note that when re-ordering devices with
smaller width, the red line can be to the left of a device (indicating that the moved device will be inserted before
the other device) or to the right of a device (indicating that the moved device will be inserted after the other de-
vice).
In this example an RV-7 reverb device is moved to two different destinations:
4. Release the mouse button.
The device(s) are moved to the new position and the other devices in the rack are adjusted to fill up the gaps.
! Note that if you start to move a device but change your mind, you can abort the operation by pressing [Esc]
while keeping the mouse button depressed.
D If you hold down [Shift] when you move a device, Reason will attempt to automatically re-route it.
See “Automatic routing” for more info on auto-routing.
In this case, the red line
indicates that the RV-7
reverb device will be
inserted to the left of
the phaser.
This is the result. Note
that the filter device is
moved to the left, to fill
out the gap.
In this case, the red line
indicates that the reverb
device will be inserted to
the right of the chorus/
flanger.
This is the result. All three
devices are moved to the
left, to fill out the gap.