Operation Manual

RECORDING IN THE SEQUENCER
101
4. Start recording on the track.
As the recording begins, the Play button on the Transport Panel goes dark while the Record button remains red.
During recording, both the Play and Record buttons are active and any input data will be recorded.
If the lane is currently empty, a new clip is automatically created on the record enabled lane on the track. As the re-
cording progresses, the clip expands following the Song Position Pointer. The clips are shaded in red during re-
cording according to the picture below:
5. When you’re done recording, click the Stop button on the Transport Panel. Alternatively, press [Spacebar], [0]
on the numeric keypad, or hold down [Shift] and press [Return].
The Record and Play buttons turn grey, the Song Position Pointer stops and the red shading of the clip(s) disap-
pears. The clip(s) show the recorded events as different types of graphical objects, depending on clip type.
! If nothing was recorded in a note clip, clicking Stop will automatically remove the empty note clip.
Undoing a recording
D If you’re not satisfied with the finished recording, you can select “Undo Record Track” from the Edit menu or
select the clip on the Edit/Arrangement Pane and press [Delete] or [Backspace].
This will delete the clip and its contents.
Undoing while recording a note clip
D If you’re not satisfied with your ongoing recording of a note clip, press [Delete] or [Backspace].
This will delete the current note clip and all its contents and at the same time create a new clip starting at the cur-
rent song position. The sequencer will continue recording during the entire process.
! Note that this only works when recording note clips.
A note clip being recorded