Operation Manual

RECORDING IN THE SEQUENCER
100
Loop mode
In loop mode, the song is automatically looped between the Left and Right Loop Locators on the Edit/Arrangement
Pane during playback and/or recording:
Loop mode activated by clicking the Loop button on the Transport Panel
The behavior when recording in loop mode differs depending on what you’re recording - MIDI or parameter automa-
tion. Refer to “Recording notes in Loop mode” and “Recording parameter automation in Loop mode”.
General recording procedure
The following description applies to all types of recording: MIDI and parameter automation. For specific details of
MIDI and parameter automation recording, refer to “Recording notes”, “Recording performance controller automation”
and “Recording parameter automation”.
1. If desired, select Click and/or Pre-count according to the descriptions in “Click and Pre-count”.
2. Move the Song Position Pointer to the position in the Ruler where you want to start your recording (see “Ruler
details”).
3. Click the Record button on the Transport Panel. Alternatively, press [*] on the numeric keypad, or hold down
[Ctrl](Win) or [Cmd](Mac) and press [Return].
The Record button turns red. If Pre-count is enabled, wait for the set number of pre-count bars before starting to
record MIDI or parameter automation. During pre-count, nothing will be recorded.
During pre-count, only the Record button is active (red) and nothing will be recorded.