Getting Started Guide
Table Of Contents
- Table of Contents
- Installation
- Setting Up
- Guided Tour
- About this Chapter
- Guided Tour
- The Rack
- The Back
- The Transport Panel
- The Sequencer
- The Tool window
- The Devices
- Reason Hardware Interface
- Combinator
- Mixer 14:2
- Line Mixer 6:2
- Subtractor Analog Synthesizer
- Thor Polysonic Synthesizer
- Malström Synthesizer
- NN-19 Digital Sampler
- NN-XT Digital Sampler
- Dr. Octo Rex Loop Player
- Redrum Drum Computer
- Kong Drum Designer
- MClass Mastering effects
- BV512 Vocoder
- Scream 4 Sound Destruction Unit
- RV7000 Advanced Reverb
- RV-7 Digital Reverb
- DDL Digital Delay Line
- D-11 Foldback Distortion
- ECF-42 Envelope Controlled Filter
- CF-101 Chorus/Flanger
- PH-90 Phaser
- UN-16 Unison
- COMP-01 Compressor
- PEQ2 Two Band Parametric EQ
- Spider Audio Merger & Splitter
- Spider CV Merger & Splitter
- The Matrix Pattern Sequencer
- RPG-8 Monophonic Arpeggiator
- ReBirth Input Machine
- Tutorial 1 - Playing a Song
- Tutorial 2 - Playing devices and selecting sounds
- Tutorial 3 - Creating a drum pattern
- Tutorial 4 - Recording a bass line
- Tutorial 5 - Adding a REX loop
- Tutorial 6 - Adding an arpeggio
- Index
GUIDED TOUR
29
The Back
If you press [Tab] or select Toggle Rack Front/Rear on the Options menu, the rack will be “turned” to show
you the back.
Here, the back panel of each device in the rack is shown. As you can see, connections between devices
are indicated by “virtual patch cables”. Connections between instrument devices and mixers use red ca-
bles, connections to or from effect devices use green cables, connections to or from Combinator devices
use blue cables and CV connections (Control Voltage, used for controlling parameters or triggering
sounds) use yellow cables. You can make connections by clicking and dragging from one “socket” to an-
other on the back panels.
To turn the rack over again (to show the front panels), use the same command.
The Transport Panel
The panel at the bottom of each song document window is called the Transport Panel. It contains transport
controls and settings such as tempo and position displays, DSP load indicator, etc.