Getting Started Guide
Table Of Contents
- Table of Contents
- Installation
- Setting Up
- Guided Tour
- About this Chapter
- Guided Tour
- The Rack
- The Back
- The Transport Panel
- The Sequencer
- The Tool window
- The Devices
- Reason Hardware Interface
- Combinator
- Mixer 14:2
- Line Mixer 6:2
- Subtractor Analog Synthesizer
- Thor Polysonic Synthesizer
- Malström Synthesizer
- NN-19 Digital Sampler
- NN-XT Digital Sampler
- Dr. Octo Rex Loop Player
- Redrum Drum Computer
- Kong Drum Designer
- MClass Mastering effects
- BV512 Vocoder
- Scream 4 Sound Destruction Unit
- RV7000 Advanced Reverb
- RV-7 Digital Reverb
- DDL Digital Delay Line
- D-11 Foldback Distortion
- ECF-42 Envelope Controlled Filter
- CF-101 Chorus/Flanger
- PH-90 Phaser
- UN-16 Unison
- COMP-01 Compressor
- PEQ2 Two Band Parametric EQ
- Spider Audio Merger & Splitter
- Spider CV Merger & Splitter
- The Matrix Pattern Sequencer
- RPG-8 Monophonic Arpeggiator
- ReBirth Input Machine
- Tutorial 1 - Playing a Song
- Tutorial 2 - Playing devices and selecting sounds
- Tutorial 3 - Creating a drum pattern
- Tutorial 4 - Recording a bass line
- Tutorial 5 - Adding a REX loop
- Tutorial 6 - Adding an arpeggio
- Index
SETTING UP
22
Adding a control surface
1. Open the Preferences dialog and select the Keyboards and Control Surfaces page.
2. If your control surface is connected via USB (or if you have made a two-way MIDI connec-
tion), try clicking the Auto-detect Surfaces button.
Reason scans all MIDI ports and tries to identify the connected control surfaces. Note that not all con-
trol surfaces support auto-detection.
All found surfaces are listed in the Attached Surfaces list.
3. To add a control surface manually, click the Add button.
This brings up a new dialog.
4. Select the manufacturer of your control surface from the Manufacturer pop-up menu.
If you can’t find it on the menu, see below.
5. Select the model of your control surface from the Model pop-up menu.
If you can’t find it on the menu, see below.