Getting Started Guide
Table Of Contents
- Table of Contents
- Installation
- Setting Up
- Guided Tour
- About this Chapter
- Guided Tour
- The Rack
- The Back
- The Transport Panel
- The Sequencer
- The Tool window
- The Devices
- Reason Hardware Interface
- Combinator
- Mixer 14:2
- Line Mixer 6:2
- Subtractor Analog Synthesizer
- Thor Polysonic Synthesizer
- Malström Synthesizer
- NN-19 Digital Sampler
- NN-XT Digital Sampler
- Dr. Octo Rex Loop Player
- Redrum Drum Computer
- Kong Drum Designer
- MClass Mastering effects
- BV512 Vocoder
- Scream 4 Sound Destruction Unit
- RV7000 Advanced Reverb
- RV-7 Digital Reverb
- DDL Digital Delay Line
- D-11 Foldback Distortion
- ECF-42 Envelope Controlled Filter
- CF-101 Chorus/Flanger
- PH-90 Phaser
- UN-16 Unison
- COMP-01 Compressor
- PEQ2 Two Band Parametric EQ
- Spider Audio Merger & Splitter
- Spider CV Merger & Splitter
- The Matrix Pattern Sequencer
- RPG-8 Monophonic Arpeggiator
- ReBirth Input Machine
- Tutorial 1 - Playing a Song
- Tutorial 2 - Playing devices and selecting sounds
- Tutorial 3 - Creating a drum pattern
- Tutorial 4 - Recording a bass line
- Tutorial 5 - Adding a REX loop
- Tutorial 6 - Adding an arpeggio
- Index
SETTING UP
17
D If Reason can't find the keyboard you have connected, or if you clicked “Don't Use”, you
will be asked to specify a master keyboard manually.
This is done by first selecting a Manufacturer, and then a model. If your model keyboard isn’t on this list
select “Other” - see below.
D You will also have to specify a MIDI port to use.
This can be done either by selecting one of the available ports listed in the popup, or by clicking the
"Find…" button and pressing some keys on your keyboard.
D Note that if you have additional remote control surface devices in your setup, these will
have to be added in the Preferences - see “About the Preferences” on page 18.
The Setup Wizard will only establish a connected Master Keyboard device.
If all went well, you should now have established audio and MIDI communication - the basics needed to
play back audio and to direct MIDI to Reason! Reason will launch and bring up the default song.
However, if for any reason the Setup Wizard failed to establish the necessary settings, or if you wish to add
other devices etc., you have to make settings in the Preferences.
Read on...