Getting Started Guide

GUIDED TOUR
27
The Back
If you press [Tab] or select Toggle Rack Front/Rear on the Options menu, the rack will be “turned” to
show you the back.
Here, the back panel of each device in the rack is shown. As you can see, connections between devices
are indicated by “virtual patch cables”. Connections between instrument devices and mixers use red ca-
bles, connections to or from effect devices use green cables, connections to or from Combinator de-
vices use blue cables and CV connections (Control Voltage, used for controlling parameters or
triggering sounds) use yellow cables. You can make connections by clicking and dragging from one
“socket” to another on the back panels.
To turn the rack over again (to show the front panels), use the same command.
The Transport Panel
The panel at the bottom of each song document window is called the transport panel. It contains trans-
port controls and settings such as tempo and position displays, DSP load indicator, etc.