Operation Manual
Table Of Contents
- Table of Contents
- The Sequencer
- Routing Audio and CV
- Remote - Playing and controlling Reason devices
- Using Reason as a ReWire Slave
- Advanced MIDI - the External Control Bus inputs
- Synchronization
- Optimizing Performance
- Transport Panel
- Reason Hardware Interface
- The Combinator
- The Mixer
- The Line Mixer 6:2
- Redrum
- Subtractor Synthesizer
- Malström Synthesizer
- NN-19 Sampler
- NN-XT Sampler
- Introduction
- Panel Overview
- Loading Complete Patches and REX Files
- Using the Main Panel
- Overview of the Remote Editor panel
- About Samples and Zones
- Selections and Edit Focus
- Adjusting Parameters
- Managing Zones and Samples
- Working with Grouping
- Working with Key Ranges
- Setting Root Notes and Tuning
- Using Automap
- Layered, Crossfaded and Velocity Switched Sounds
- Using Alternate
- Sample Parameters
- Group Parameters
- Synth parameters
- Connections
- Dr. Rex Loop Player
- Matrix Pattern Sequencer
- ReBirth Input Machine
- BV512 Vocoder
- The Effect Devices
- Common Device Features
- The MClass effects
- The MClass Equalizer
- The MClass Stereo Imager
- The MClass Compressor
- The MClass Maximizer
- Scream 4 Sound Destruction Unit
- RV7000 Advanced Reverb
- RV-7 Digital Reverb
- DDL-1 Digital Delay Line
- D-11 Foldback Distortion
- ECF-42 Envelope Controlled Filter
- CF-101 Chorus/Flanger
- PH-90 Phaser
- UN-16 Unison
- COMP-01 Auto Make-up Gain Compressor
- PEQ-2 Two Band Parametric EQ
- Spider Audio Merger & Splitter
- Spider CV Merger & Splitter
- Menu and Dialog Reference
- About Audio on Computers
- MIDI Implementation
- Index
THE LINE MIXER 6:2
95
Connections
All input and output connectors are as usual located on the back panel of the Line
Mixer.
Mixer Channel Connections
D Each mixer channel features stereo left/right inputs for connecting audio
devices.
Use the left input when manually connecting a mono signal source.
D In addition, there is a Control Voltage (CV) input, for voltage controlling
channel Pan from other devices.
Auxiliary (AUX) Send
D The Send connectors are used to connect to the inputs of effect devices.
To connect the send to a mono-input device, use the Left (Mono) output.
When a Send is connected to an effects device, the corresponding AUX Send knob
determines the level of the signal sent to the effect device for each channel.
The Send Output can be taken Pre or Post channel level by using the switch to the
left of the Send connectors.
Auxiliary (AUX) Return
These are normally connected to the left and right outputs of effect devices.
Master Left/Right Outputs
D The Master outputs are auto-routed to the first available input pair on
the Audio Hardware interface, or another mixer.
If used in a Combi, the Master Outs are normally connected to the “From Devices”
connectors on the Combinator.