Operation Manual
Table Of Contents
- Table of Contents
- The Sequencer
- Routing Audio and CV
- Remote - Playing and controlling Reason devices
- Using Reason as a ReWire Slave
- Advanced MIDI - the External Control Bus inputs
- Synchronization
- Optimizing Performance
- Transport Panel
- Reason Hardware Interface
- The Combinator
- The Mixer
- The Line Mixer 6:2
- Redrum
- Subtractor Synthesizer
- Malström Synthesizer
- NN-19 Sampler
- NN-XT Sampler
- Introduction
- Panel Overview
- Loading Complete Patches and REX Files
- Using the Main Panel
- Overview of the Remote Editor panel
- About Samples and Zones
- Selections and Edit Focus
- Adjusting Parameters
- Managing Zones and Samples
- Working with Grouping
- Working with Key Ranges
- Setting Root Notes and Tuning
- Using Automap
- Layered, Crossfaded and Velocity Switched Sounds
- Using Alternate
- Sample Parameters
- Group Parameters
- Synth parameters
- Connections
- Dr. Rex Loop Player
- Matrix Pattern Sequencer
- ReBirth Input Machine
- BV512 Vocoder
- The Effect Devices
- Common Device Features
- The MClass effects
- The MClass Equalizer
- The MClass Stereo Imager
- The MClass Compressor
- The MClass Maximizer
- Scream 4 Sound Destruction Unit
- RV7000 Advanced Reverb
- RV-7 Digital Reverb
- DDL-1 Digital Delay Line
- D-11 Foldback Distortion
- ECF-42 Envelope Controlled Filter
- CF-101 Chorus/Flanger
- PH-90 Phaser
- UN-16 Unison
- COMP-01 Auto Make-up Gain Compressor
- PEQ-2 Two Band Parametric EQ
- Spider Audio Merger & Splitter
- Spider CV Merger & Splitter
- Menu and Dialog Reference
- About Audio on Computers
- MIDI Implementation
- Index
BV512 VOCODER
219
Creating a stereo reverb
What you’ve got above is a mono reverb. Here’s how to make it stereo:
1. Select the Subtractor and create a Spider Audio Merger & Splitter device.
2. Create a DDL-1 delay.
3. Connect the devices in the following way:
The Subtractor output should be routed to a Splitter input on the Spider. One split
output should be routed to one of the carrier inputs on the vocoder, the other split
output should be routed to the delay. The delay output (mono) should be routed to
the other carrier input on the vocoder.
The vocoder will now get a “fake-stereo” noise carrier signal.
4. Make sure the output from the vocoder is connected in stereo to the Aux re-
turn on the Mixer.
5. Finally turn down the Feedback on the delay, set it to all “wet” and set the de-
cay time to a second or so.
When you now start playback on the Redrum, the reverb will be in stereo!