Operation Manual
Table Of Contents
- Table of Contents
- The Sequencer
- Routing Audio and CV
- Remote - Playing and controlling Reason devices
- Using Reason as a ReWire Slave
- Advanced MIDI - the External Control Bus inputs
- Synchronization
- Optimizing Performance
- Transport Panel
- Reason Hardware Interface
- The Combinator
- The Mixer
- The Line Mixer 6:2
- Redrum
- Subtractor Synthesizer
- Malström Synthesizer
- NN-19 Sampler
- NN-XT Sampler
- Introduction
- Panel Overview
- Loading Complete Patches and REX Files
- Using the Main Panel
- Overview of the Remote Editor panel
- About Samples and Zones
- Selections and Edit Focus
- Adjusting Parameters
- Managing Zones and Samples
- Working with Grouping
- Working with Key Ranges
- Setting Root Notes and Tuning
- Using Automap
- Layered, Crossfaded and Velocity Switched Sounds
- Using Alternate
- Sample Parameters
- Group Parameters
- Synth parameters
- Connections
- Dr. Rex Loop Player
- Matrix Pattern Sequencer
- ReBirth Input Machine
- BV512 Vocoder
- The Effect Devices
- Common Device Features
- The MClass effects
- The MClass Equalizer
- The MClass Stereo Imager
- The MClass Compressor
- The MClass Maximizer
- Scream 4 Sound Destruction Unit
- RV7000 Advanced Reverb
- RV-7 Digital Reverb
- DDL-1 Digital Delay Line
- D-11 Foldback Distortion
- ECF-42 Envelope Controlled Filter
- CF-101 Chorus/Flanger
- PH-90 Phaser
- UN-16 Unison
- COMP-01 Auto Make-up Gain Compressor
- PEQ-2 Two Band Parametric EQ
- Spider Audio Merger & Splitter
- Spider CV Merger & Splitter
- Menu and Dialog Reference
- About Audio on Computers
- MIDI Implementation
- Index
NN-XT SAMPLER
184
The other output pairs are never automatically routed. If you wish to use any of the
other output pairs, you have to manually connect them to the desired device - typically
a mixer channel. The basics on Routing is described in the chapter “Managing the
Rack” in the Getting Started book.
! Note that when you use any other output pair than the first, you also have
to route one or more zones to it if you want it to actually output sound,
since all zones by default are routed to outputs 1 & 2. How to route zones
to other outputs is described on page 175.