Operation Manual

The Mixer
85
Connections
All input and output connectors are as usual located on the back panel of the
Mixer 14:2. Special connectors are used for “chaining” two or more Mixers to-
gether. This is described on page 86.
Mixer Channel Connections
DD
DD
Each mixer channel features stereo left/right inputs for connecting
audio devices.
Use the left input when manually connecting a mono signal source.
DD
DD
In addition, there are two Control Voltage (CV) inputs (with associ-
ated voltage trim pots), for voltage controlling channel Level and
Pan from other devices.
Auxiliary (AUX) Send Out
DD
DD
There are four mono Send Out connectors, which normally are used
to connect to the inputs of effect devices.
When a Send is connected to an effects device, the corresponding AUX
Send knob determines the level of the signal sent to the effect device for
each channel. The Send Output is taken post-channel fader.
! Note that some effects (for example the Comp-01 compressor or
the PEQ2 parametric EQ) are effect types which are not designed to
be used as AUX Send effects, but rather as insert effects, where the
whole signal is passed through the effect.
Auxiliary (AUX) Returns
DD
DD
There are four stereo Return input connectors.
These are normally connected to the left and right outputs of effect devices.
Master Left/Right Outputs
DD
DD
The Master outputs are auto-routed to the first available input pair
on the Audio Hardware interface.
This in turn sends the audio to the outputs of your audio hardware.
✪ Note that the Master outputs don’t have to be routed directly to the
Audio Hardware Interface. You could for example route the Master
outputs to an effect, and then route the effect outputs to the Hard-
ware Interface instead.
DD
DD
In addition, there is a Control Voltage (CV) input (and an associated
trim pot), for voltage controlling the Master Level from another de-
vice.