User Manual

RV7000 MK II ADVANCED REVERB
925
The main panel
The RV7000 Mk II main panel.
When you create an RV7000 Mk II, only the main panel will be shown. This contains a section for handling patches,
on/off buttons for the EQ and Gate sections, the most important reverb parameters and a dry/wet mix control. To se-
lect a reverb patch and make coarse adjustments, this is all you need.
The Remote Programmer
Clicking the arrow button next to the “cable slot” on the main panel brings up the remote programmer panel.
This is where you make detailed settings for the reverb. Note:
• The Edit Mode button to the left determines which section to make settings for, Reverb, EQ or Gate.
• Settings are made with the eight dials around the graphic display. The functions of the dials differ depending
on the selected Edit Mode and the selected reverb algorithm. Next to each dial, the display shows the name
and value of the corresponding parameter.
• Not all modes and algorithms use all eight dials. If a dial isn’t used in the selected mode, nothing will be shown
next to it in the display.
• You cannot make settings in the graphic display itself - this is for showing a graphic representation of the se-
lected reverb.