User Manual

PULVERISER
905
Modulation inputs and outputs
CV Modulation inputs
On the back of Pulveriser you will find CV inputs for controlling the following parameters:
Squash
Use this for dynamically changing the amount of compression in the Squash section.
Dirt
Use this for dynamically changing the amount of distortion in the Dirt section.
Filter Frequency
Use this for dynamically changing the Frequency parameter in the Filter section.
Tremor Rate
Use this for dynamically changing the LFO Rate parameter in the Tremor section.
If the LFO is in Sync mode, the rate will jump between the different resolutions according to the CV modulation input
signal amount.
Volume
Use this for dynamically changing the output volume from Pulveriser.
Follower
Use this for controlling the envelope follower signal from an external source. The internal envelope follower signal is
replaced with the CV signal that is inserted here.
! Note that the Attack and Release controls can still be used to shape the CV input signal.
Audio Modulation inputs
! Note that these modulation inputs accept audio rate signals, which is really cool!