User Manual

NN-XT SAMPLER
763
LFO 1 Amt
This determines how much the amount of modulation from LFO 1 is affected by the Modulation wheel and/or the Ex-
ternal Controller wheel. It does this by “scaling” the amounts set with the three destination knobs in the LFO 1 section
(Pitch, Filter and Level, see “The LFOs”). We’ll explain this with an example:
To use the Modulation Wheel to
increase pitch modulation (vibrato), proceed as follows:
1. Turn the Mod Wheel all the way down, so that no modulation is applied.
2. Activate the “W” button for LFO 1 Amt in the Modulation section.
3. Set the corresponding knob to “12 o’clock” (zero).
4. Set up LFO 1 so that as much vibrato is applied as you want it to be when the Modulation wheel is turned all
the way up.
5. Increase LFO 1 Amt until you hear as much vibrato as you want it to be when the wheel is turned all the way
down.
If you turn LFO 1 Amt all the way up, there will be no vibrato at all when the wheel is all the way down.
To instead use the Modulation wheel to
decrease vibrato, process as follows:
1. Turn the Mod Wheel all the way down, so that no modulation is applied.
2. Activate the “W” button for LFO 1 Amt in the Modulation section.
3. Set the corresponding knob to “12 o’clock” (zero).
4. Set up LFO 1 so that as much vibrato is applied as you want it to be when the Modulation wheel is turned all
the way down.
5. Turn the Modulation wheel all the way up.
6. Decrease LFO 1 Amt until you hear as much vibrato as you want it to be when the wheel is turned all the way
up.
If you turn LFO 1 Amt all the way down, there will be no vibrato at all when the wheel is all the way up.
F.Res
This sets modulation control of the Resonance parameter in the Filter (see “The Filter section”).
Level
This sets the amount of amplitude envelope modulation of each zone’s level. The level set here will be the level of the
highest point of the Amp Envelope.
LFO 1 Rate
This sets modulation control of the Rate parameter in LFO 1 (see “The LFOs”).