User Manual

NN-19 SAMPLER
720
Connections
On the back panel of the NN-19 you will find the connectors, which are mostly CV/Gate related.
Audio Outputs
These are the main left and right audio outputs. When you create a new NN-19 device, these are auto-routed to the
first available channel on the audio mixer.
Mono Sequencer Control
These are the main CV/Gate inputs. CV controls the note pitch. Gate inputs trigger note on/off values plus a level,
which can be likened to a velocity value. If you want to control the NN-19 from a Matrix Pattern Sequencer for exam-
ple, you would normally use these inputs. The inputs are “mono”, i.e. they control one voice in the sampler.
Modulation Inputs
! Remember that CV connections will not be stored in the sample patch, even if the connections are to/from the
same NN-19 device!
These control voltage (CV) inputs (with associated voltage trim pots), can modulate various NN-19 parameters from
other devices, or from the modulation outputs of the same NN-19 device. These inputs can control the following pa-
rameters:
• Osc (sample) Pitch
• Filter Cutoff
• Filter Resonance
•Amp Level
•Mod Wheel
Modulation Outputs
The Modulation outputs can be used to voltage control other devices, or other parameters in the same NN-19 device.
The Modulation Outputs are:
• Filter Envelope
•LFO