User Manual

COMMON OPERATIONS AND CONCEPTS
54
Inspector segment displays
The segment displays in the Inspector can be edited as shown in the following Position display examples. The Posi-
tion display segments show (from left to right) Bars, Beats, 1/16th Note and Ticks:
The other segment displays in the sequencer Inspector can be edited in the same way as described above.
Tool Tips
If you hover with the mouse over a control on a device panel and wait a moment, a tool tip appears. The tool tip shows
the name of the parameter associated with that control and its current value. This helps you fine-tune settings, set
several parameters to the same value, etc.
D You can turn off the Tool Tips function by deactivating the option “Show parameter value tool tip” in the “Ap-
pearance” section on the General page in Preferences.
Click the up/down buttons to change the value in steps of 1 Bar (the
leftmost segment).
Click in the display to select either the Bar, Beat, 1/16th note or Ticks
segment. Then, click the up/down buttons to change the value of the
selected segment in steps of 1 unit.
Click in the display to select either Bar, Beat, 1/16th note or Ticks. Then,
click and drag the cursor up/down to change in steps of 1 unit.
Alternatively, change the value with the mouse scrollwheel. You can also
use the [Up]/[Down] arrow keys on the computer keyboard.
Double-click in the display. Then, type in the desired value and press
[Enter].
Click in the display to select either Bar, Beat, 1/16th note or Ticks. Then,
type in a number and press [Enter].
Alternatively, select a segment, type in a number preceded by a [+] to add
or a [-] to subtract the number from the current value. Then, press [Enter].