User Manual

WORKING WITH BLOCKS IN THE SEQUENCER
297
Arrangement Views
Song View (with Blocks disabled)
The sequencer in the Song View.
This is the Song View, which is the same as “Arrange Mode” in older versions of the program. Here you work with
your song in a linear fashion, by recording and arranging your clips from the start of the song to the end. Songs cre-
ated in previous versions of the program will automatically open up in the Song View, so it will all look very familiar.
Song View (with Blocks enabled)
When you create a new song, or a song from a template, the sequencer will automatically have the Blocks function
activated. However, if you open a song that was previously saved with the Blocks function off, you will have to manu-
ally activate Blocks:
D Select “Enable Blocks” on the Options menu to enable the Blocks function.
The sequencer in Song View with “Enable Blocks” activated
With Enable Blocks activated on the Options menu, an additional track - the Blocks Track - becomes available
above the Transport Track. On the Blocks Track you can arrange your Block Automation Clips once you have re-
corded your Blocks. There are also two buttons to the left on the Blocks Track in the Track List: the Block and
Song View buttons.
Blocks Track
Block View button
Song View button