User Manual

NOTE AND AUTOMATION EDITING
279
Editing parameter automation in Edit Mode
1. Open the parameter automation clip in Edit Mode.
D If the parameter automation clip is on an Instrument Track, just double-click a Note clip to enter Edit Mode.
D If the parameter automation clip is not on an Instrument Track, first double-click the automation clip and then
click the “Open In Edit Mode” button.
Use the dividers if necessary to locate the automation clip to edit - these are located at the bottom of the Edit/Ar-
range Pane (not in the note clip). Parameter automation clips are distinguished by a “cut off” upper right corner.
An instrument track in Edit Mode with parameter automation clips at the bottom.
2. Open the parameter automation clip for editing by double-clicking it or by selecting it and pressing [Return].
The parameter automation clip is now open for editing.
The “Parameter 1” automation clip open for editing in Edit Mode.
In Edit Mode, the parameter’s Static Value is shown to the left in the automation lane. In this example, the Static
Value is set to 20 - this means that the “Parameter 1” value will be set to 20 everywhere in the song except where
there are automation clips for the parameter.
D To change the Static Value, click and drag the handle up or down, or double-click and type in a new value.
To fine adjust the Static Value, hold down [Shift] when you click and drag.
q The Static Value can also be edited in the Song/Block view, see “Editing parameter automation in the Song/
Block View”.
Parameter automation
clips in Edit Mode
Parameter automation
clip open for editing
Static Value handle