User Manual

AUDIO EDITING IN THE SEQUENCER
209
Joining notes
To join notes, proceed as follows:
1. Select the Eraser tool from the Toolbar.
2. Click on a note that you want to join with the preceding note, or click in the corresponding section in the Clip
Overview.
The new “joint” note is now re-analyzed and placed on the suitable pitch position in the note range. This could
mean that the new note is placed differently than the original notes.
D To join several notes in one go, draw a selection rectangle with the Eraser tool and then release the mouse
button.
The result will be one long note, re-analyzed and placed on the most suitable pitch position in the note range.
About switching from Pitch Edit mode to Slice Edit mode
! When you have edited an audio clip in Pitch Edit mode and then switch to Slice Edit mode (with the “Vocal”
Stretch and Transpose Type still selected), the slices are now based on the note transitions from Pitch Edit
mode, and not on the level transients.
Audio pitch editing in the Inspector
In Pitch Edit mode a series of additional audio pitch editing boxes appear in the Inspector. These are unique to the
Pitch Edit mode and apply to selected notes on the note pane:
The Inspector elements for a selected note in Pitch Edit mode.
Position
Here you can edit the start position of the note in Bars, Beats, 1/16th notes and Ticks.