User Manual

Table Of Contents

PULSAR DUAL LFO

1051

D Select waveform for each LFO by clicking the up/down arrow buttons or by clicking and holding in the wave-

form display and dragging up/down.

Level

Here you set the output level of the LFO signal. The LFO 1 Level can be modulated by LFO 2, see “Level (LFO 2 to

LFO 1 Level)”. The Levels can also be modulated by the Envelope, see “Envelope”.

Phase

The Phase control lets you offset the phase of the LFO cycle, i.e. decide where in the cycle the waveform should

start. The range of the Phase control is 0-360 degrees:

Shuffle

The Shuffle function affects two adjacent LFO cycles, in pairs. Increasing the Shuffle value lengthens the first cycle

and shortens the second one:

Note that the total length of the cycle pair is always 2 regular cycles, which means that shuffling will work great also

in Tempo Sync mode, see “Tempo Sync”.

Range: 50% (no shuffle) to 75%

Phase=270Phase=0 Phase=90 Phase=180

Shuffle=50%

Shuffle >50%