12.2

KONG DRUM DESIGNER110
D Alternatively, drag a REX file from the Browser and drop on the Nurse Rex panel.
The Nurse Rex panel is dimmed in orange and a Patch Replace symbol appears in the center.
The REX file is loaded in Nurse Rex with the loop shown in the display.
Hit Types (playback modes)
Depending on selected Hit Type, the REX loop will play back differently. The editing possibilities also differs depend-
ing on selected Hit Type for the assigned pad.
•Loop Trig
In Loop Trig mode, you trig the REX loop to play one single cycle every time you hit the assigned pad. Loop Trig
can also be used together with the “Stop” mode on another pad to immediately stop the loop playback, see “Stop”
below.
A REX loop with “Loop Trig” as Hit Type.
D Set Start and End slice, either by clicking and dragging the S and E numerical values up/down in the boxes, or
by clicking and dragging the handles sideways in the “ruler” above the REX loop in the display.
Different ways of editing the Start and End Slice values.
• Chunk Trig
In Chunk Trig mode, you can assign several pads to play back shorter sections - chunks - of the REX loop. The
number of chunks is determined by the number of pads you have assigned to the REX loop using the Chunk Trig
Hit Type. The chunks are distributed in equal sections across the REX loop. Chunk Trig can also be used together
with the “Stop” mode on another pad to immediately stop the chunk playback, see “Stop” below.
In the picture below, we have assigned four pads to the same REX loop and we have selected “Chunk Trig” as Hit
Type on all four pads:
Four pads assigned to the same REX loop and Hit Type set to “Chunk Trig”.
Loop range (Start and End)
Four Chunks distributed
equally across the REX loop
Pad 1-4 assigned to the same
Nurse Rex module