11.3

EUROPA SHAPESHIFTING SYNTHESIZER195
The Effects section
The Effects section features six different effect modules that can be freely reordered by dragging & dropping. Most
of the effect parameters are also available as destinations in the Modulation Bus, see “The Modulation Bus section”.
At the top of the Effects section are six Effect buttons. Click any of these to bring up the control panel for the corre-
sponding effect. Below the Effect buttons are the On/Off buttons for the individual effects. Click these to activate the
effects.
Reordering the effects
D To define the order of the effects in the serial chain, click and hold on the desired Effect button and drag side-
ways to the desired position:
Moving the Reverb effect to another position in the effects chain.
You can reorder the effects at any time.
Reverb
This is a stereo reverb, routed as a send effect.
• Decay
This governs the length of the reverb effect.
•Size
Sets the emulated room size, from small room to large hall. Middle position is the default room size.
Lowering this parameter results in a closer and gradually more “canned” sound. Raising the parameter results in a
more spacey sound, with longer pre-delay.
•Damp
Raising the Damp value cuts off the high frequencies of the reverb, thereby creating a smoother, warmer effect.
•Amount
Use this parameter to adjust the send level to the Reverb effect.
If you play a note, have a long delay Decay time and turn down Amount, the reverberation will continue.